![]() Check all wheel bolts or lug nuts in the same sequence and retighten to the prescribed tightening torque if necessary.Tighten the wheel bolts or lug nuts to the specified tightening toque in a crosswise sequence using a calibrated torque wrench.Screw in the wheel bolts or lug nuts and evenly tighten by hand in a crosswise sequence in order to centre the wheel rim.The wheel rim must rest uniformly against the brake disc.Attention! Do not apply oil or grease to wheel studs or bolts. Clean wheel bolts or nuts and check threads for damage, renew if necessary.Apply anti-seize paste on the wheel centring in the wheel rim.Check brake disc retaining bolt for tight fit.Remove dirt, grease residues and corrosion from rim and wheel hub contact surfaces.Do not jump or use your foot on the breaker bar. Always release the wheel lockable nuts or bolts by hand (use a breaker bar) and NOT by using an impact drill.Never get under the vehicle when it is resting only on the jack. Always block the opposite wheel from the one you are working on with two wheel chokes on both side of the wheel to prevent the car from rolling and fall of the jack while you're working on it. ![]() When lifting your vehicle, make sure you use the proper equipment and that you only lift the vehicle from the jacking points, one wheel at the time. When removing and installing a wheel on your vehicle, always follow these generic instructions, but for more information please refer to your owner's manual. ![]() Remove or Install Front or Rear Wheel - Generic Instructions For 20 BMW models wheel bolt torque specs updates, please scroll to the last two rows at the bottom of the table below. BMW Wheel Bolt Torque Specs, RecommendationsīMW Wheel Bolt Torque specs for BMW vehicles up to 2018. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |